Friday 30 May 2014

How to Light Road Flares?

Lighting LED power flare is quite easy; however, there are few safety precautions which should to be taken while using them. There is involvement of fire and you wish to ensure that you, everybody in your automobile, and the emergency workers, are as safe as probable.

Below are some simple steps to light road safety flares:
 
• Find the correct location: Ensure that you place road flares on flat part of road. There must be no grass around the flares that can catch fire. Not just should you’ve the road flare near your vehicle, there also should be one about 100 steps from front of your car, and one at same distance behind. It will make easier for approaching traffic to notice you.

• Remove cap: At one side of flare, there probably will be cap to cover rough striking surface. So, remove it before doing any other thing. Check to observe if cap is made up of fold out tab or flat side, which can help to keep flare from rolling while it’s on ground. Now, twist end of cap to remove it gently from the flares.

• Hold flare away: When you’re lighting road flares, it is vital that you hold flare as much far as you possibly can from your own body.

• Light flare: Use surface such as pavement to light the road flare. You’ll strike flare in same manner like you would do a match. Keep in mind to move the flare always from your body when you’re striking it, but not towards you. This flare will spray little bit, therefore hold it as much far from the body as possible.

• Place flare: Carry flare to wherever you want to put it, pointing flame down. Put cap on unlit end of flare to use it as stand, and then put the flare on ground carefully. Don’t drop it, as you’ll not get any control on where it lands. En sure that you put the flare where it’s not going to get near other combustible materials.

• Extinguish flames: After you’re ready to get on the road back, it is vital that you turn off any LED safety flares that still are burning. If you don’t have any water to douse them, tap them against ground to break the burning part, and it will extinguish quickly. Don’t bother trying to suffocate this kind of flame as it most probably is not going to completely work, and you’ll be just wasting your time.

No comments:

Post a Comment